Denon AVR-4311CI Owner's Manual page 108

Setting items
GUI TUNER : Set the tuner screen display time when the input source is
(Continued) "SIRIUS" or "HD Radio".
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
• Always : Show display continuously.
Remote Preset Codes See "Registering preset codes" (vpage 108).
Search a preset code to
register in the remote
control unit.
Quick Select Name • Up to 16 characters can be input.
Change the "Quick Select" • For character input, see page 78.
display title to one you
prefer.
Zone Rename • Up to 10 characters can be input.
Change the display title of • For character input, see page 78.
each zone to one you prefer.
Trigger Out 1 /
Trigger Out 1/2
Trigger Out 2
n When setting for zone (MAIN ZONE / ZONE2 / ZONE3)
Select the condition for
Trigger out is activated through linkage to the power of the zone set
activating Trigger Out 1/2 for
to "ON".
the input source, surround
n When setting for input source
mode, etc.
Activate trigger out when the input source set to "ON" is selected.
See "TRIGGER OUT jacks"
(vpage 27) for more
Active for the zone set to "ON" with "When setting for zone".
information on trigger out.
n When setting for surround mode
Activate trigger out when the surround mode set to "ON" is selected.
Active when the "MAIN ZONE" set to "ON" with "When setting
for zone" is selected, and when the input source set to "ON" with
"When setting for input source" is selected.
n When setting for HDMI monitor
Activate trigger out when the HDMI monitor set to "ON" is selected.
Activate trigger out when the HDMI monitor set to "ON" is
selected. Active when the "MAIN ZONE" set to "ON" with
"When setting for zone" is selected, and when the input source
set to "ON" with "When setting for input source" is selected.
n When setting for "Vertical Stretch"
Activate trigger out through linkage when "Vertical Stretch" (vpage 98)
is set to "ON".
• ON : Activate trigger on this mode.
• – – – : Do not activate trigger on this mode.
Remote control operation
buttons
Setting details
Move the cursor
(Up/Down/Left/Right)
Setting items
Remote ID 1 / 2 / 3 / 4
Set when you operate
NOTE
another DENON AV
When changing the remote ID, also change the remote ID of main remote
amplifier with the remote
control unit (RC-1145) at the same time. Also change the sub remote
control unit of this unit.
Match the remote control control unit (RC-1148) at the same time.
unit you are using with the
remote ID of this unit.
Dimmer Bright : Normal display brightness.
Adjust the display Dim : Reduced display brightness.
brightness of this unit. Dark : Very low display brightness.
OFF : Turns the display off.
Setup Lock ON : Turn protection on.
Protect settings from OFF : Turn protection off.
inadvertent change.
When canceling the setting, set "Setup Lock" to "OFF".
NOTE
When "Setup Lock" is set to "ON", the settings listed below can no
longer be changed. Also, "SETUP LOCKED!" is displayed if you attempt
to operate related settings.
• Menu operations
• RESTORER
• Dolby Volume
• Dynamic Volume ®
Maintenance Mode
NOTE
Use when receiving
Only use this function if so instructed by a DENON serviceperson or
maintenance from a DENON
installer.
service engineer or custom
installer.
Confirm the setting
MANUAL SETUP
Setting details
• Channel Level
• MultEQ ® XT 32
• Dynamic EQ ®
105
Return to previous menu