Adjusting The Volume Of The Speakers - Denon AVR-4311CI Owner's Manual

Sleep timer function
The power automatically goes into standby once the set time has
elapsed.
This is convenient for playing sources while going to sleep.
SLEEP
Press and display the time you
want to set.
The indicator on the display lights.
• The time switches as shown below each
SLEEP
time is pressed.
OFF 10 min 20 30
120 110 100 90 80
To confirm the countdown time before putting the
unit to sleep
SLEEP
Press .
"Sleep : zmin" appears on the display.
z Countdown time
To cancel the sleep timer
SLEEP
Press to set "OFF".
The indicator on the display turns off.
• The sleep timer setting is canceled if this unit's power is set to
standby.
• The sleep timer function can be set separately for the different zones
(vpage 74 "Sleep timer function").
66

Adjusting the volume of the speakers

You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
n Adjusting the volume of the different speakers
1
ZONE SELECT
Press
zone mode to
The indicator lights.
M
2
Press AMP
40 50
control unit to AMP-operation
mode.
70 60
3
Press CH LEVEL
CHANNEL LEVEL
Front L -8.0dB
Front R -12.0dB
Subwoofer1
Subwoofer2
Subwoofer
4
Use ui to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
5
Use o p to adjust the volume.
• You can directly turn "OFF" the subwoofer outputs during
2-channel playback in DIRECT or STEREO mode.
Select "Subwoofer" and use
Front L
Front R
Subwoofer
When a headphone jack is inserted, the headphone channel level can
be adjusted.
to switch the
(MAIN ZONE).
M
to set the remote
.
0.0dB
0.0dB
ON
o p to select "ON" or "OFF".
CHANNEL LEVEL
-8.0dB
-12.0dB
OFF
n Adjusting the volume of groups of speakers
(Fader function)
This function lets you adjust (fade) the sound all at once from the
front (front speaker / front height speaker / front wide speaker /
center speaker) or rear (surround speaker / surround back speaker).
1
Press ZONE SELECT to switch the zone mode to
(MAIN ZONE).
The M indicator lights.
2
AMP
Press to set the remote
control unit to AMP-operation
mode.
3
CH LEVEL
Press .
4
Press i to select "Fader", then
select the item to be adjusting
using o p.
CHANNEL LEVEL
Front L -8.0dB
Front R -12.0dB
Front Height L 0.0dB
Front Height R 0.0dB
Front Wide L -12.0dB
Front Wide R -10.0dB
Center 0.0dB
Subwoofer1 0.0dB
Subwoofer2 0.0dB
Surround L -12.0dB
Surround R -10.0dB
Fader Front Rear
5
Use o p to adjust the volume of the speakers.
(o : front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker is adjusted
to the lowest value of –12 dB.
Convenient functions
M