Denon AVR-4311CI Owner's Manual page 37

n Checking the SIRIUS signal strength and radio
ID
1
Press STATUS until
"SIGNAL" appears on the
display.
The display will switch as shown
below, depending on the reception
conditions.
Display Status
EXCELLENT Signal strength is excellent
Signal strength is good
GOOD
WEAK Signal strength is weak
NO SIGNAL No signal
2
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
3
STATUS
Press until the channel (example: "SR001")
is displayed.
4
TUNING d TUNING f
Press or
and select channel 0 (SR000).
Channel No. and Sirius ID are alternately
shown on the display.
SR000 SiriusID
Sirius ID
************
• Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS satellite and terrestrial signals can be
checked "Antenna Aiming" (vpage 81).
34
n Presetting radio channels (Preset memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel
you want to preset.
2
Press MEMORY .
3
Press SHIFT to select the block
(A to G) in which to preset the
channel (1 to 8 per block), then
press CH + , CH – or 1 – 8 to select
the preset number.
4
Press MEMORY again to complete
the setting.
• To preset other stations, repeat steps 1 to
4.
NOTE
Preset channels are erased by overwriting them.
n Listening to preset channels
Press CH + , CH – to select the desired
ENTER
preset channel, then press .
• Preset channels can also be selected by
SHIFT 1 – 8
pressing (Block) and (Channel).
You can also operate via the main unit.
In this case, perform the following
operations.
TUNING PRESET
Press , then turn
SOURCE SELECT
to select the preset
radio channel.
n Searching categories
1
Press .
o p
SR001 Hits 1
Channel category
CAT : Pops
2
Use to select the category, to use
o p
the desired channel.
n Accessing SIRIUS satellite radio channels
directly
1
Press SEARCH .
2
Press 0 – 9 to input the channel.
Example: Accessing channel "SR123":
1 2 3
Press , and .
• If no button is pressed within several
seconds, the channel automatically
switches to the one whose number has
been input.
3
Press ENTER to set that channel.
Reception switches to the selected
channel.
• "UPDATING" is displayed while the encording code is being
updated.
• "SIRIUS UPDATING" is displayed when updating SIRIUS tuner
firmware.
• Refer to "Troubleshooting" – "SIRIUS Satellite Radio" (vpage 136)
regarding other messages.
Tuning in radio stations
to select
ui