Resetting The Microprocessor - Denon AVR-4311 Owner's Manual

ENGLISH
GRemote Control UnitH
Symptom
The set cannot be • Batteries are worn out. Replace with new batteries.
operated with the • Operate the remote control unit within a distance of about 7 m
remote control unit. from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set's remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
• Make sure the remote control IDs of the main unit and remote
control unit match. If the IDs do not match, "AVAMPz" (z is the
main unit's remote control ID) appears on the display of this unit
when the remote control unit is operated.
• The ZONE SELECT setting is not correct. Press
select the zone to operate.
• The operation mode does not match the settings of the device to
operate. Check the operation mode.
134
Cause/Solution
ZONE SELECT
to

Resetting the microprocessor

Page
Perform this procedure if the display is abnormal or if operations cannot be performed.
120
When the microprocessor is reset, all the settings are reset to their default values.
120
ON/STANDBY
120
120
120
101, 110,
114
104
1
Turn off the power using
104
2
Press ON/STANDBY
SIMULATION
.
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
STANDARD
DSP SIMULATION
ON/STANDBY .
while simultaneously pressing STANDARD and DSP