Restoring All The Settings To As They Were At The Time Of Purchase (Resetting The Microprocessor) - Denon AVR-1910 Owner's Manual

GHDMIH
Symptom Cause
HDMI audio • The "Manual Setup" – "HDMI
signals are not Setup" – "HDMI Audio Out"
output from setting is set to"TV"
speakers.
No picture • The connections to the HDMI
appears connectors are faulty.
with HDMI • HDMI input setting is improper.
connections. • The monitor is not compatible
with copyright
(HDCP).
• The HDMI format of the player
and monitor do not match.
No sound is • The "Manual Setup" – "HDMI
output from Setup" – "HDMI Audio Out"
the monitor setting is set to "Amp" .
connected
with HDMI
connections.
When performing • HDMI's CEC function
the following operating.
operations on a
connected device,
AVR-1910 has the
same operations.
⋅ Power ON/OFF
⋅ Switching audio
output devices
⋅ Adjust volume
⋅ Switch input
source
GiPodH
Symptom Cause
iPod cannot be • The input source assigned to
played. "iPod Dock" is not selected.
• Cable is not properly connected.
• Control dock for iPod's AC
adapter is not connected to
power outlet.
Countermeasure
• Set to "Amp"
• Check the connections.
• Check the HDMI input setting.
• Connect a monitor that is
protection compatible with copyright
protection (HDCP).
• Match the HDMI format of the
player and monitor.
• Set to "TV" .
is • Set "Manual Setup" – "HDMI
Setup" -– "HDMI Control" to
"OFF" .
When you only want to operate
the power on/off each device, set
"Power Off Control" to "OFF" .
Countermeasure
• Switch to the input source
assigned at "iPod Dock" .
• Reconnect.
• Plug the control dock for iPod's
AC adapter into a power outlet.
Restoring all the settings to as they were at the
Page
time of purchase
28
(Resetting the Microprocessor)
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
1
13
Turn off the power using
33
12 2
Press while simultaneously pressing
12
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
28
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
28
Page
33
14
–
on the main unit.
and on the main unit.
ENGLISH