Configure Bandwidth Settings - D-Link xStack DXS-3250E Web/Installation Manual

Configure Bandwidth Settings

The Bandwidth Settings Page allows network managers to define the bandwidth settings for a specified egress
interface. Modifying queue scheduling affects the queue settings globally.
Queue shaping can be based per queue and/or per interface. Shaping is determined by the lower specified value.
The queue shaping type is selected in the Bandwidth Settings Page. To define bandwidth settings:
1. Click Basic Setup > Quality of Service > Global Parameters > Bandwidth. The Bandwidth Settings Page
opens:
Figure 194: Bandwidth Settings Page
The Bandwidth Settings Page contains the following fields:
•
Unit no. — Indicates the stacking members for which the bandwidth settings are displayed.
•
Port — Indicates the port that is being displayed.
•
Ingress Rate Limit — Indicates the Ingress traffic limit for the port.
–
Status — Indicates the traffic limit status.
–
Rate limit — Indicates the rate limit.
•
Egress Shaping Rates — Configures the traffic shaping type for selected interfaces. The possible field val-
ues are:
–
CIR — Defines CIR as the queue shaping type. The possible field value is 4096 - 1,000,000,000 bits per
second.
–
CBS — Defines CBS as the queue shaping type. The possible field value is 4096-16,000,000 bytes.
Page 279
Configuring Quality of Service
Defining General QoS Settings