Defining Vlan Interface Settings - D-Link xStack DXS-3250E Web/Installation Manual

Defining VLAN Interface Settings

The VLAN Interface Settings Page contains fields for managing ports that are part of a VLAN. The Port Default
VLAN ID (PVID) is configured on the VLAN Interface Settings Page. All untagged packets arriving at the device
are tagged with the port PVID. To define VLAN interfaces:
1. Click Basic Setup > VLAN > Membership > Interface Settings. The VLAN Interface Settings Page opens.
Figure 113: VLAN Interface Settings Page
The VLAN Interface Settings Page contains the following fields:
The Page contains two separate tables including information on VLAN Interface Settings for ports and for Global
System LAGS.
•
Interface — Displays the port number included in the VLAN.
•
Interface VLAN Mode — Displays the port mode. The possible values are:
–
Customer — Indicates the port belongs to a customer VLAN in which all ports are double tagged.
–
General — Indicates the port belongs to VLANs, and each VLAN is user-defined as tagged or untagged
(full IEEE802.1q mode).
–
Access — Indicates a port belongs to a single untagged VLAN. When a port is in Access mode, the
packet types which are accepted on the port cannot be designated. Ingress filtering cannot be enabled or
disabled on an access port.
–
Trunk — Indicates the port belongs to VLANs in which all ports are tagged, except for one port that can
be untagged.
•
Multicast TV VLAN — Indicates the Multicast VLAN ID to which the source ports and receiver ports are
members.
Page 179
Configuring VLANs
Defining VLAN Interface Settings