D-Link xStack DXS-3250E Web/Installation Manual page 36

Note
The following screen is an example configuration.Items such as addresses, versions, and dates may differ
for each device.
Preparing to decompress...
Decompressing SW from image-1
638000
OK
Running from RAM...
*********************************************************************
*** Running SW Ver. x.x.x.x Date 11-Jan-200x Time 15:43:13 ***
*********************************************************************
HW version is
Base Mac address is: 00:00:b0:24:11:80
Dram size is: xxM bytes
Dram first block size is: 47104K bytes
Dram first PTR is: 0x1200000
Flash size is: xM
Devices on SMI BUS:
-------------------
smi dev id = 16, dev type=0xd0411ab, dev revision=0x1
Device configuration:
Prestera based - Back-to-back system
Slot 1 - DB-DX240-24G HW Rev. xx.xx
Tapi Version: xx.x.x-x
Core Version: xx.x.x-x
01-Jan-200x 01:01:22 %INIT-I-InitCompleted: Initialization task is
completed
Console> 01-Jan-200x 01:01:23 %LINK-I-Up:
01-Jan-200x 01:01:23 %LINK-W-Down:
01-Jan-200x 01:01:23 %LINK-I-Up:
01-Jan-200x 01:01:23 %LINK-W-Down:
.
.
.
01-Jan-200x 01:01:23 %LINK-W-Down:
01-Jan-200x 01:01:23 %LINK-W-Down:
01-Jan-200x 01:01:23 %LINK-W-Down:
After the switch boots successfully, a system prompt appears (console>) and the local terminal can be used to begin
configuring the switch. However, before configuring the switch, ensure that the software version installed on the device is
the latest version. If it is not the latest version, download and install the latest version. See "Software Download and
Reboot."
e1
e2
Vlan 1
e4
e46
e47
e48
Page 35
Initial Configuration