Configuring The Terminal; Installation Procedure; Device Port Default Settings - D-Link DES-3010FA Web User Manual

D-Link DES-3010FA/GA User Guide

Configuring the Terminal

After completing all external connections, connect a terminal to the device to monitor the boot and other
procedures.
To configure the device, the terminal must be running terminal emulation software.
Ensure that the terminal emulation software is configured as follows:
1. Connect the Chassis serial port to the switch module. The baud rate automatically boots up at 9600.
2. Set the data format to 8 data bits, 1 stop bit, and no parity.
3. Set Flow Control to none.
4. Under Properties, select VT100 for Emulation mode.
5. Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that the setting is for Terminal keys (not
Windows keys).
Note
When using HyperTerminal with Microsoft
Pack 2 or later is installed. With Windows 2000 Service Pack 2, the arrow keys function properly in
HyperTerminal's VT100 emulation. Go to www.microsoft.com for information on Windows 2000 service
packs.

Installation Procedure

The order of installation and configuration procedures is illustrated in the following figure. For the initial
configuration, the standard device configuration is performed.
Performing other functions is described later in this section.

Device Port Default Settings

The following table describes the device port default settings.
Table 10: Port Default Setting
Fu nc tio n
Port speed and mode
Port forwarding state
Head of line blocking prevention
Flow Control
Back Pressure
Note
These default settings can be modified once the device is installed.
®
Windows 2000, make sure that Windows
De fa ul t Se tti n gs
100M Auto-negotiation
Enabled
On (Enabled)
Off
Off
Page 32
®
2000 Service