User Name; Snmp Community Strings - D-Link DES-3010FA Web User Manual

D-Link DES-3010FA/GA User Guide
console (config) # ip default-gateway 100.1.1.110
console (config) # snmp-server community private rw
console(config)# exit
console#
Verifying the IP and Default Gateway Addresses
To ensure that the IP address and the default gateway were properly assigned, execute the following command
and examine its output:
console # - ip interface
Gateway IP Address
--------------------- ---------------
192.168.1.1
IP address
--------------
192.168.1.123/24

User Name

A user name is used to manage the device remotely, for example through SSH, Telnet, or the Web interface. To
gain complete administrative (super-user) control over the device, the highest privilege (15) must be specified.
Note
Only the administrator (super-user) with the highest privilege level (15) is allowed to manage the device
through the web browser interface.
For more information about the privilege level, see the CLI Reference Guide.
The configured user name is entered as a login name for remote management sessions. To configure a user
name, password, and privilege level, enter the command at the system prompt as shown in the configuration
example:
console> enable
console# configure
console(config)# username admin password lee privilege 15

SNMP Community Strings

Simple Network Management Protocol (SNMP) provides a method for managing network devices. Devices
supporting SNMP run a local software agent. The SNMP agents maintain a list of variables, used to manage the
device. The variables are defined in the Management Information Base (MIB). The SNMP agent defines the MIB
specification format, as well as the format used to access the information over the network.
Access rights to the SNMP agents are controlled by access strings and SNMP community strings.
The device is SNMP-compliant, and contains an SNMP agent that supports a set of standard and private MIB
variables. Developers of management stations require the exact structure of the MIB tree and receive the
complete private MIBs information before being able to manage the MIBs.
All parameters are manageable from any SNMP management platform, except the SNMP management station IP
address and community (community name and access rights). The SNMP management access to the switch is
disabled if no community strings exist.
Activity status
Active
Interface Type
----------- ------
VLAN 1 Static
Page 36