Defining Snmp Notification Global Parameters - D-Link DES-3010FA Web User Manual
Layer 2 switch, managed 8 port 10/100base-tx with gigabit & fiber uplinks
Hide thumbs
Also See for DES-3010FA:
- Cli manual (361 pages) ,
- Cli manual (348 pages) ,
- Manual (348 pages)
Table of Contents
Advertisement
D-Link DES-3010FA/GA User Guide
Defining SNMP Notification Global Parameters
The SNMP Notification Properties Page contains parameters for defining SNMP notification parameters. To define
SNMP notification global parameters:
1.
Click System > SNMP > Notification > Properties. The SNMP Notification Properties Page opens:
Figure 112: SNMP Notification Properties Page
The SNMP Notification Properties Page contains the following fields:
•
Enable SNMP Notifications — Specifies whether the device can send SNMP notifications. The possible
field values are:
–
Enable — Enables SNMP notifications.
–
Disable — Disables SNMP notifications.
•
Enable Authentication Notifications — Specifies whether SNMP authentication failure notification is
enabled on the device. The possible field values are:
–
Enable — Enables the device to send authentication failure notifications.
–
Disable — Disables the device from sending authentication failure notifications.
2.
Define the Enable SNMP Notification and Enable Authentication Notifications fields.
3.
Click
. The SNMP notification properties are defined, and the device is updated.
Page 176
Advertisement
Table of Contents
Troubleshooting
