Priority Watch - Icom IC-2350H Instruction Manual

Mi Priority watch operation
© Watching a memory or call channel
@) Push the desired band's tuning dial.
(@) Select VFO mode; then, set an operating frequency.
© Push the selected band's [M/CALL] once or twice to
select a memory channel or call channel.
- "ŒP or "C" appear.
@ Push [DTMF-PRIO] for 2 sec. to start the priority watch.
- The transceiver checks a memory or call channel frequency
every 5 sec.
- The watch resumes according to the selected scan resume
condition. (p. 30)
-While the watch is pausing, pushing the watching band's
[V/MHz] resumes the watch manually.
© The VFO and the other band can be used for normal
operation.
- When a signal is received on the watching frequency, the VFO
communication will be interrupted.
© Push the watching band's [M/CALL] while the display
shows the VFO frequency to stop the watch.
ne pausing on the watching chan-
nel or frequency, "PRIO" flashes.
PRIORITY WATCH 9
© Watching memory channels
@ Push the desired band's tuning dial.
@ Select VFO mode; then, set an operating frequency.
(3) Push the selected band's [M/CALL] once or twice to
select memory mode.
- "W" appears.
@ Push [LOW-SCAN] for 2 sec. or [UP]/[DN] on the
microphone for 2 sec. to start the memory scan.
© Push [DTMF-PRIO] for 2 sec. to start the priority watch.
- The transceiver checks memory channel frequencies every 5
sec., in sequence.
- The watch resumes according to the selected scan resume
condition. (p. 30)
-While the watch is pausing, pushing the watching band's
[V/MHzZ] resumes the watch manually.
© The VFO and the other band can be used for normal
operation.
- When a signal is received on the watching frequency, the VFO
communication will be interrupted.
@ Push the watching band's [M/CALL] while the display
shows the VFO frequency to stop the watch.