Scan Resume Setting; Priority Watch - Icom ic-80fx Instruction Manual

■ Scan resume setting

When a signal is received during a scan, the scan resume
setting determines what action the transceiver takes. The
transceiver has two scan resume settings, as described
below. Use the Set mode to select the one which best suits
your needs.
q Push [FUNC](M), and then [SET](8) to enter the Set mode.
w Push [ ] or [ ] to select the scan pause timer item (SCt,
or SCP).
e Rotate [VOL] to select a scan pause option.
• Pause scan
The scan pauses until the received signal disappears,
and then resumes after 2 seconds.
• Timer scan
The scan pauses for 5 seconds, 10 seconds or 15 sec-
onds, and then resumes.
r Push [# ENT](MN.W) to exit the Set mode.
[VOL]
Pause scan
Timer scan (15 seconds)

■ Priority watch

The priority watch checks for signals on the selected chan-
nel (Priority channel) every 5 seconds.
The priority channel must be set fi rst, using the optional CS-
80FX .
CLONING SOFTWARE
q Push [FUNC](M), and then [PRIO](7) to start the watch.
.
• The decimal point " " on the alphanumeric display blinks.
• When a signal is detected on the channel, the watch pauses,
and then resumes according to the scan resume setting. (p. 30)
w To cancel the watch, push any key except [
[FUNC], [ ] or [MONI].
Operating channel
5 seconds
NOTE: When you start the priority watch, the Tone func-
tion is automatically turned OFF and the output power
is automatically returned to the level set in the CS-80FX
cloning software.
SCAN OPERATION
], [ ]/[ ],
Priority channel
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20