Scan Operation - Icom IC-2350H Instruction Manual

W Full scan and programmed
scan
The procedure for full scan and programmed scan is the
same. Previously used scan or a scan preset in set mode is
activated.
@ Push the desired band's tuning dial.
@ Select VFO mode with the selected band's [V/MHz]
switch.
@ Set the selected band's [SQL] to the point where noise is
muted.
@ Push [UP]/[DN] on the microphone for 2 sec. or
[LOW-SCAN] for 2 sec. to start the scan.
- When the optional tone squelch is in use, [LOW*SCAN] starts
the tone scan. (p. 18) Use [UP]/[DN}] in this case.
- To change the scanning direction, rotate the scanning band's
tuning dial.
- Memory channel readout shows the selected scan types as
follows:
e "AL" : Full scan is selected.
e "P1": Programmed scan is selected.
®© Push [SET] to alternate between full scan and pro-
grammed scan, if desired.
© To stop the scan, push [UP]/[DN] or [LOW-SCAN].
SCAN OPERATION 8
"P1" indicates the
—_~+—— programmed scan is
a ee activated.
"AL" indicates the full
scan is activated.
© Scan resume condition:
- When receiving a signal, scan resumes in one of the
following ways:
e after pausing 15 sec.
e after pausing 10 sec.
e after pausing 5 sec.
e after the signal disappears or appears.
- The scan
resume condition can
be selected in set
mode. (p. 30)
- While scanning,
rotating the tuning dial changes the
scanning direction or skips a paused frequency.