Ates O E A Aiai; Frequency Setting; Turning Power On/Off - Icom IC-2350H Instruction Manual

—f
E Pre-operation
© Turning power ON/OFF
Push and hold [POWER] for 2 sec. to turn power ON or OFF.
Push and hold [POWER] for 2 sec.
lf auto power-off is in use, the transceiver automatically
turns the power OFF after a selected period in which no
switches or tuning dials are operated. (p. 45)
OS
© Main band
The IC-2350H can receive 144 MHz and 430(440) MHz band
signals simultaneously. To activate all functions or to change
frequency via the microphone, you must designate one band
as the main band. The transceiver can transmit a signal on
the main band only.
Push the desired band's tuning dial to select the main band.
- "(ENT" indicator shows the selected band as the main band.
FREQUENCY SETTING
© VFO and memory modes
The transceiver has 2 normal operating modes: VFO mode
and memory mode. You can select VFO mode or memory
mode independently on each band.
Push the desired band's [V/MHz] to seiect VFO mode when
the transceiver is not in VFO mode.
- If VFO mode is already selected, the digits below 100 kHz disap-
pear. In this case, push [V/MHZz] again.
VFO mode is selected. indicates memory mode.