TRENDnet TE100-P11 User Manual page 85

Problem No. 7 My old printer cannot print or prints garbage.
Solution No. 7 If the printer you used is an old model with low speed, the following
steps may solve this problem:
•
•
•
Problem No. 8 How Do I Print to the Print Server's printer from a MS-DOS
program?
Solution No. 8 Set the MS-DOS program to use LPT1 (parallel port 1) then "Capture"
the output and re-direct it to the Print Server's printer.
Windows 98/ME
1. Select Start - Settings - Printers to open the Printers folder.
2. Right-click the Print Server's Printer, and select Properties
3. On the Details tab, click the Capture button to see the Capture
4. On this dialog:
Windows 2000/XP/Vista
1. Login as Administrator.
2. Open the command prompt window.
3. Enter the following command:
Where
e.g.
To terminate this capture, use the following command at the command
prompt:
Open the BiAdmin Utility.
Click the Printer Status icon.
For the parallel port, change the Printer Type setting to Low Speed
or set the Handshake Signal setting to Ack & Busy.
Printer Port button, shown below.
•
Select the Device, normally LPT1 (parallel port 1).
•
Enter or select the Path to the printer:
\\printer_name\P1
Where
printer_name
e.g.
\
\TN3000014\P1
•
Check the Reconnect at logon checkbox. If this is not done, the
capture setting will be lost when Windows is restarted.
net use lpt1 \\printer_name\P1 /persistent:yes
printer_name
net use lpt1 \\TN3000014\P1 /persistent:yes
net use lpt1 /delete
is the actual name of your printer.
is the actual name of your printer.
Page 82