TRENDnet TE100-P11 User Manual page 73

IPP Client Setup - Windows 2000/XP
Windows 2000 and XP have their own IPP Client, and there is no need to install the supplied
IPP Client Software. To use the Windows IPP Client with the Print Server, follow this
procedure:
1. Start the Add Printer wizard.
2. Select Network Printer, and click "Next" to see the Locate your Printer screen, as shown
below.
3. Select Connect to a printer on the Internet or on your Intranet, and enter the URL of the
IPP Server as follows, where ip_address represents the IP Address of the IPP Server,
and 631 is the port number.
Port 1
4. If the connection can be established, and the printer on that port is on-line, the following
dialog will be displayed.
5. Click "OK", and then select the printer manufacturer and model to match the printer
connected to the port on the IPP Server.
6. Click "Next", and complete the Wizard.
The IPP printer is now ready for use.
Figure 4: Windows 2000 - Locate your Printer
These entries are case sensitive. They must be
entered as shown, with "ipp" in lower case, and
P1 in UPPER case.
Figure 5: Windows 2000: No printer driver
ip_address:631/ipp/P1
Page 70