TRENDnet TE100-P11 User Manual page 29

In future, you can use Start > Programs > TRENDnet > Print Server Utility - Printer Port
Setup to run the program again.
PTP Printer Port Setup
1. The Printer Port setup program searches for Printer Servers on the network, and a screen
like the following is displayed.
•
If desired, click Refresh.
•
The name of the attached printer will be displayed if possible. If "No printer" is
displayed, check that the printer is properly connected and powered on.
If your Print Server is not listed:
•
Click the "Refresh" button.
•
Check that both the Print Server and the printer are properly connected, and
powered on.
•
Check that the Print Server has been configured. (Use the Setup Wizard on
the CD-ROM.)
•
If using TCP/IP, try installing the NetBEUI protocol. (See the earlier section
Checking your Network Protocols for details.). Then try again.
2. Select the desired port on a Print Server, and then click Next. A pop-up message will
inform you if the port has been created successfully.
Page 26