Table of Contents
Advertisement
9-6-4. Adding NCW-3DNIP to the controller project
Add the NCW-3DNIP to the controller project as an I/O device.
There are two ways to add NCW-3DNIP as described below.
①In case EDS file is installed (refer to section 9-6-4-1)
②In case EDS file isn't installed (refer to section 9-6-4-2)
9-6-4-1. In case EDS file is installed
(1) Right-click the "Ethernet" in the I/O Configuration folder, and choose "New Module".
47
Advertisement
Table of Contents
Need help?
Do you have a question about the ABSOCODER NCW-3DNIPLW and is the answer not in the manual?