Honeywell 4600RSF051CE User Manual page 64

Preferred Symbology classifies each symbology as high priority, low priority,
or as an unspecified type. When a low priority symbology is presented, the
imager ignores it for a set period of time (see
page 3-17) while it searches for the high priority symbology. If a high priority
symbology is located during this period, then that data is read immediately.
If the time-out period expires before a high priority symbology is read, the
imager will read any barcode in its view (low priority or unspecified). If there is
no barcode in the imager's view after the time-out period expires, then no data
is reported.
Note: A low priority symbol must be centered on the aiming pattern to be read.
Scan a barcode below to enable or disable Preferred Symbology. Default =
Preferred Symbology Off.
Preferred Symbology On
High Priority Symbology
To specify the high priority symbology, scan the High Priority Symbology bar-
code below. On the
want to set as high priority. Locate the Hex value for that symbology and scan
the 2 digit hex value from the Programming Chart (inside back cover). Scan
Save to save your selection. Default = None
Low Priority Symbology
To specify the low priority symbology, scan the Low Priority Symbology bar-
code below. On the
want to set as low priority. Locate the Hex value for that symbology and scan
the 2 digit hex value from the Programming Chart (inside back cover).
If you want to set additional low priority symbologies, scan FF, then scan the 2
digit hex value from the Programming Chart for the next symbology. You can
program up to 5 low priority symbologies. Scan Save to save your selection.
Default = None
3 - 16
Symbology Chart
High Priority Symbology
Symbology Chart
Low Priority Symbology
Preferred Symbology Time-out
* Preferred Symbology Off
on page A-1, find the symbology you
on page A-1, find the symbology you
on