Download  Print this page

Chapter 12 - Serial Programming Commands; Conventions; Menu Command Syntax - Honeywell 4600RSF051CE User Manual

Commercial/retail/industrial area imager.
Hide thumbs


Serial Programming Commands
The serial programming commands can be used in place of the programming
barcodes. Both the serial commands and the programming barcodes will pro-
gram your imager. For complete descriptions and examples of each serial pro-
gramming command, refer to the corresponding programming barcode in this
The device must be set to an RS-232 interface (see
commands can be sent via a PC COM port using terminal emulation software.


The following conventions are used for menu and query command descriptions:
parameter A label representing the actual value you should send as part of a
[ option ]

Menu Command Syntax

Menu commands have the following syntax (spaces have been used for clarity
Prefix Tag SubTag {Data} [, SubTag {Data}] [; Tag SubTag {Data}] [...] Storage
An optional part of a command.
Alternatives in a command.
Names of menus, menu commands, buttons, dialog boxes, and
windows that appear on the screen.
Three ASCII characters: SYN M CR (ASCII 22,77,13).
A 3 character case-insensitive field that identifies the desired menu
command group. For example, all RS-232 configuration settings
are identified with a Tag of 232.
A 3 character case-insensitive field that identifies the desired menu
command within the tag group. For example, the SubTag for the
RS-232 baud rate is BAD.
The new value for a menu setting, identified by the Tag and Sub-
A single character that specifies the storage table to which the
command is applied. An exclamation point (!) performs the com-
mand's operation on the device's volatile menu configuration table.
A period (.) performs the command's operation on the device's
non-volatile menu configuration table. Use the non-volatile table
only for semi-permanent changes you want saved through a power
1-11). The following
12 - 1


   Related Manuals for Honeywell 4600RSF051CE

Comments to this Manuals

Symbols: 0
Latest comments: