Download  Print this page

In-stand Sensor Mode (4600r Only) - Honeywell 4600RSF051CE User Manual

Commercial/retail/industrial area imager.
Hide thumbs

Advertisement

Low Power Time-Out Timer
Scan the Low Power Time-Out barcode to change the time-out duration (in
seconds). Then scan the time-out duration (from 0-300 seconds) from the
inside back cover, and Save. Default = 120 seconds.
If the unit remains idle during the low power time-out interval, the unit goes into
low power mode. Whenever the trigger is enabled, the low power time-out timer
is reset.
Note: This time-out does not begin until the imager time-out setting has expired.

In-Stand Sensor Mode (4600r only)

Note: This feature is only applicable to the flex stand with sensor
(HFSTAND5RSE) used with a 4600r, software revision 31205480-118 or
higher. To determine whether you have the correct hardware and
software, scan the Sensor On barcode. If it triple beeps, your device
does not have this capability.
This feature tells a 4600r to sense when the scanner is removed from the stand
and to begin manual triggering. When you scan Sensor On, the imager goes
into manual trigger mode when it is removed from the stand. For example, if
the 4600r is programmed for
sentation mode whenever it is in the stand, and in manual trigger mode when-
ever it is removed from the stand. Default = Sensor Off.
Sensor On
Low Power Time-Out
Presentation Mode
(page 3-7), it would be in pre-
* Sensor Off
3 - 5

Advertisement

   Related Manuals for Honeywell 4600RSF051CE

Comments to this Manuals

Symbols: 0
Latest comments: