Roles And Permissions Panel - Extron electronics SW USB Pro Series User Manual

Roles and Permissions Panel

In this panel (see figure
NOTES:
The following rules apply to passwords:
• Length is 1-128 characters.
•
All human-readable characters are permitted except | .
• The password cannot be a single space unless you are removing the password entirely.
•
Passwords are case-sensitive.
Setting a password
NOTE: The initial factory configured passwords for all accounts on this device have been set to the device
serial number. Passwords are case sensitive. In the event of an absolute system reset, the passwords are
reset to extron.
The web password is administrator level. Passwords are case sensitive.
To assign new administrator and user passwords:
1. In the
Roles and Permissions
2. In the
panel, click the Change Admin Password link and enter the new administrator in the field below
Admin
(see figure 23,
1
3. Click in the Confirm Admin Password field (
field.
Figure 23. Role and Permission Settings Dialog Box with Administrator Password Entered
4. If you want to assign a user password, repeat steps 2 and 3 in the
5. When finished, click Save to set the passwords. To close the window without saving a password, click Cancel
or the X in the upper-right corner.
To remove an assigned user password:
1. In the Change User Password field, enter a single space.
2. Enter a single space in the appropriate Confirm Password field.
3. Click Save. The user password is removed.
NOTE: An administrator password cannot be removed. If you enter a single space in the Admin Password
field, it is replaced with extron as the unit password.
17, on page 28) you can set and remove administrator and user passwords.
4
panel, click Edit. The
).
Role and Permission Settings
) and repeat the password from the Change Admin Password
2
User
SW USB Pro Series • Internal Web Page
dialog box opens
panel ( ).
3
31