Device Status Panel - Extron electronics SW USB Pro Series User Manual

3. Double-click the firmware file name. The
the
Update Firmware
Figure 18. Firmware Update Dialog Box with a Firmware File Selected
4. Click Update to begin (
the
Update Firmware
During the updating process, a window appears in the middle of the screen, showing the progress of the
update: Uploading,
Figure 19. Firmware Update Progress Window
When the update is completed, the progress window closes and the message
appears near the top of the screen. The new firmware filename appears beside
of the web page.

Device Status Panel

The panel (see
Device Status
amount of time the device has been running (
Syncing the unit to the PC
To set the SW USB Pro date and time to match that of your computer:
Click Sync to PC at the bottom of the
figure 20 appears in the upper-right corner of the screen.
Figure 20. Sync to PC Success Message
Open
panel on the web page (see figure 18,
). (If you want to cancel the update, click the X button in the upper-right corner of
2
panel.)
,
Initializing Writing to Flash
figure 17, , on the previous page) displays the current date, time, time zone, the
3
Uptime
Device Status
window closes, and the selected firmware file name appears in
.
1
, and (see figure 19).
Rebooting
), and internal temperature in degrees Celsius.
panel. When the sync is completed, the message shown in
SW USB Pro Series • Internal Web Page
Firmware Upload Complete
in the
Version Firmware
panel
29