Effect Parameters; Mix Balance - Yamaha M7CL Owner's Manual

J Output meter
Indicates the level of the signal being output from the internal effect.
K Parameter display select button
If "046 REV-X Hall," "047 REV-X ROOM," "048 REV-X PLATE," or VCM effect is selected as the effect type, this
button switches between the standard parameter screen and a dedicated GUI screen.
L
M
N
O
P
P PLAY/REC (Play/Record) buttons
If "042 FREEZE" is selected as the effect type, you can use these buttons to record and play back the signal being
input to the effect.
Q

Effect parameters

This area shows the effect parameters and knobs for the currently selected effect type.
L

MIX BALANCE

Adjusts the balance of the effect sound relative to the original sound. 0 (%) outputs
only the original sound, and 100 (%) outputs only the effect sound.
M TEMPO
If a tempo-type or modulation-type effect is selected, this allows you to adjust time-
related parameters such as DELAY (delay time) and FREQ. (modulation speed).
To set the value of the TEMPO parameter, you can either input the BPM (Beats Per
Minute) in the numerical box, or repeatedly click the TAP TEMPO button at the
desired tempo.
If the MIDI CLK button is on, the TEMPO parameter value will synchronize to the
MIDI timing clock being received from the MIDI port.
N SOLO
If "044 M.BAND DYNA" or "045 M.BAND COMP" are selected as the effect type, these
buttons allow you to monitor only the specified band from the three bands HIGH,
MID, and LOW.
O GR meter
If "044 M.BAND DYNA" or "045 M.BAND COMP" are selected as the effect type, this
indicates the gain reduction amount for the H (HIGH), M (MID), and L (LOW) bands.
Q
63 M7CL V3 Editor Owner's Manual