Yamaha M7CL Owner's Manual page 18

K
L
M
N
O
P
Q
K PAN/TO STEREO MONO
The PAN knob adjusts the panning of the signal that is sent from the INPUT CH to the
STEREO bus L/R channels (or the L/C/R channels). You can set this to the center value
by holding down the <Ctrl>(< >) key of your computer keyboard and clicking this
knob.
The [ST] button is an on/off switch for the signal that is sent from the INPUT CH to
the STEREO bus.
The [M(C)] button is an on/off switch for the signal that is sent from the INPUT CH to
the MONO bus.
If LCR MODE is selected in the Selected Channel window, the [LCR] button will appear
instead of the [ST] button and [M(C)] button, and the [LCR] button will be an on/off
switch for the signal that is sent from the INPUT CH to the LCR bus.
L SEL (Select)
Selects the INPUT CH for which you want to perform operations. This is linked with
the INPUT section [SEL] keys on the M7CL console panel.
If the Channel Select / Sends On Fader checkbox in the System Setup dia-
NOTE
log box is not checked, this will not be linked with the M7CL console.
M
CUE
This button cue-monitors the signal of the INPUT CH. This is linked with the INPUT
section [CUE] keys on the M7CL's panel.
If the Channel Select / Sends On Fader checkbox in the System Setup dia-
NOTE
log box is not checked, this will not be linked with the M7CL console.
N ON
Switches the INPUT CH or send on/off. In normal mode, this button is linked with the
CH [ON] key in the INPUT section on the M7CL console panel.
The button is color-coded and indicates status as follows:
White: INPUT CH is on (normal mode)
Black: INPUT CH/Send are off.
Other colors: Send is on (SENDS ON FADER mode).
O Fader
Adjusts the input level of the INPUT CH, or the send level. In normal mode, this fader
is linked with the fader in the INPUT section on of the M7CL console panel.
The fader is color-coded and indicates status as follows:
White: You can adjust the input level of the INPUT CH (normal mode).
Gray: INPUT CH is off.
Other colors: You can adjust the send level (SENDS ON FADER mode).
The current fader value is shown in the numerical box located immediately below the
fader.
You can set this to the minimum value (–∞ dB) by holding down the <Ctrl>(< >) key
of your computer keyboard and clicking the fader knob, or set it to the nominal value
(0.00 dB) by holding down the <Ctrl>(< >) key and <Shift> key and clicking the
fader knob.
18 M7CL V3 Editor Owner's Manual