Yamaha M7CL Owner's Manual page 21

7
8
9
J
K
L
M
N
O
G DYN1/DYN2 (Dynamics 1//Dynamics 2)
These buttons switch the two dynamics processors on/off. This is the same as the
dynamics 1/dynamics 2 for INPUT CH (➥ p.17).
H MIX/MATRIX SEND
Switches between the send indications to MIX buses 1–16 or to MATRIX buses 1–8.
This is the same as the mix/matrix send for INPUT CH (➥ p.17).
I
BALANCE
The BALANCE knob adjusts the balance of the signal that is sent from the ST IN chan-
nel to the STEREO bus L/R channels (or the L/C/R channels). Other than the BAL-
ANCE knob, this is the same as PAN/TO STEREO MONO for an INPUT channel
(➥ p.18).
J SEL (Select)
Selects the ST IN channel for which you want to perform operations. (L and R can be
selected separately.) This is linked with the ST IN section [SEL] keys on the M7CL's
panel.
If the Channel Select / Sends On Fader checkbox in the System Setup dia-
NOTE
log box is not checked, this will not be linked with the M7CL console.
K CUE
This button cue-monitors the signal of the ST IN channel (L/R are linked). This is
linked with the ST IN section [CUE] keys on the M7CL's panel.
If the Channel Select / Sends On Fader checkbox in the System Setup dia-
NOTE
log box is not checked, this will not be linked with the M7CL console.
L
ON
Switches the ST IN channel on/off (the L/R settings are linked). This is linked with the
ST IN section CH [ON] keys on the M7CL's panel.
The button is color-coded and indicates status as follows:
White: ST IN channel is on (normal mode)
Black: ST IN channel/Send are off.
Other colors: Send is on (SENDS ON FADER mode).
M
Fader
Adjusts the input level of the ST IN channel. When the M7CL itself is in other than
SENDS ON FADER mode, this is linked with the INPUT section faders of the M7CL's
panel.
The fader is color-coded and indicates status as follows:
White: You can adjust the input level of the ST IN channel (normal mode).
Gray: ST IN channel is off.
Other colors: You can adjust the send level (SENDS ON FADER mode).
The current fader value is shown in the numerical box located immediately below the
fader. This is the same as the fader for INPUT CH ( ➥ p.18).
N Channel number
This is the number of the ST IN channel. You can double-click this number to open the
Selected Channel window for this channel. If you hold down the <Ctrl>(< >) key of
your computer keyboard and double-click this, the Selected Channel window will open
as an additional view.
O
Channel name
This is a text box that displays the channel name. You can also edit the channel name in
this text box.
21 M7CL V3 Editor Owner's Manual