Yamaha M7CL Owner's Manual page 31

❏ TO MIX/TO MATRIX SEND
A MIX/MATRIX send level
This adjusts the send level of the signal sent from the input channel to VARI-type MIX bus and MATRIX bus. The
current value is shown in the numerical box immediately below.
B PRE (PRE/POST)
This selects PRE or POST as the point from which the signal is sent from the input channel to the MIX bus and
MATRIX bus. The point will be PRE POINT when this is on, and POST FADER when this is off. The PRE POINT
setting can be specified in the Mixer Setup dialogbox.
Right-click the PRE button to display a context-sensitive menu that will enable you to specify ALL PRE,
NOTE
ALL POST, or other options.
C ON (MIX/MATRIX send on/off)
This is an on/off switch for the signal sent from the input channel to the MIX bus and MATRIX bus.
HINT
• If MIX buses or MATRIX buses are being used in stereo, the
odd-numbered knob will be PAN.
• If the FIXED type is selected for the MIX bus, only the ON but-
ton is valid.
• The stereo/mono setting and the VARI type / FIXED type setting can be made in the Mixer Setup dialogbox.
D
Channel name
This section indicates the name of the MIX channel or MATRIX channel.
❏ HA GAIN/Ø/HPF
A HA (HA Gain)
Adjusts the gain of the internal head amp or of the external head amp (e.g., Yamaha AD8HR, SB168-ES) patched
to the input channel. The current value is shown in the numerical box below the knob. You can set this to the
default value (+10 dB) by holding down the <Ctrl>(< >) key and clicking the knob. You can also use the [48V]
button to switch phantom power on/off.
B
Ø (Phase)
Inverts the phase of the signal after AD conversion.
1
1
3
Knob of odd-num-
bered side
2 3
31
2
4
Knob of odd-
numbered
side
M7CL V3 Editor Owner's Manual