Yamaha M7CL Owner's Manual page 45

C ON(FROM MIX, ST/MONO send on/off)
These are on/off switches for the signal sent from the MIX buses or STEREO/MONO buses to the MATRIX bus.
HINT
• If MIX buses and MATRIX buses are being used in stereo, the
odd-numbered knob will be PAN.
• If the FIXED type is selected for the MIX bus, only the ON but-
ton is valid.
• The stereo/mono setting and the VARI type / FIXED type setting can be made in the Mixer Setup dialogbox.
D Channel name
This section indicates the name of the MIX channel or STEREO/MONO channel.
❏ BALANCE
This is shown only if the selected MATRIX bus is being used as stereo. It adjusts the left/right volume balance of
the stereo signal. You can set this to the center value by holding down the <Ctrl>(< >) key of your computer
keyboard and clicking this knob.
❏ EQUALIZER
This is the same as for the equalizer of a MIX channel (➥ p.42).
❏ DYNAMICS1
Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S,
and that you can select more than one signal as the key-in signal, this is the same as the dynamics for input chan-
nels (➥ p.34).
❏ INSERT
Except for the fact that the insert points that can be selected are different, this is the same as for the insert settings
of an input channel (➥ p.38).
❏ RECALL SAFE/MUTE SAFE
These are the same as the RECALL SAFE/MUTE SAFE of a MIX channel (➥ p.43).
❏ MUTE GROUP
These are the same as the MUTE GROUP of a MIX channel (➥ p.43).
PAN (odd-numbered side)
45 M7CL V3 Editor Owner's Manual