HMS Networks Intesis IN485FGL001I000 User Manual page 15

DIP switches
Table 3. Dip switch SW2 when the gateway is set for Modbus RTU: (P1 to P6): Modbus server address; (P7):
Degree decimals setting (P8): Temperature unit (°C/°F)
Binary value
b0 .. b7 1 2 3
1 0 0 0 0 0 X X ON OFF OFF
0 1 0 0 0 0 X X OFF ON OFF
1 1 0 0 0 0 X X ON ON OFF
...
1 0 1 1 1 1 X X ON OFF ON
0 1 1 1 1 1 X X OFF ON ON
1 1 1 1 1 1 X X ON ON ON
X X X X X X 0 X X X X
X X X X X X 1 X X X X
X X X X X X X 0 X X X
X X X X X X X 1 X X X
Table 4. DIP switch SW3: (P1 to P3): BACnet/Modbus polarization and termination resistor
Binary value Position
b0 .. b2 1 2 3
0 X X OFF X X
1 X X ON X X
X 0 0 X OFF OFF
X 1 1 X ON ON
IMPORTANT
The DIP switches configuration will only take effect after rebooting the gateway.
USER MANUAL Version 1.0.9
Position
Modbus address
4 5 6 7 8
OFF OFF OFF X X
OFF OFF OFF X X
OFF OFF OFF X X
ON ON ON X X
ON ON ON X X
ON ON ON X X
X X X OFF X
X X X ON X
X X X X OFF
X X X X ON
EIA-485 bus without termination resistor. The gateway is not at one end of the EIA-485 bus (default value)
120 Ω termination resistor active. The gateway is at one end of the EIA-485 bus
No bus polarization (default value)
Description
1
2
3
...
61
62
63
Temperature values in Modbus register are
-
represented in degrees x1 (default)
Temperature values in Modbus register are
-
represented in degrees x10. Example: 19.2°=192
- Temperature in Celsius (default)
- Temperature in Fahrenheit
Description
Bus polarization active
IN485FGL001I000 Gateway
-
-
-
-
-
-
-
Page 11 of 74