Restore The Factory Settings - HMS Networks Intesis IN485FGL001I000 User Manual

IN485FGL001I000 Gateway

6. Restore the Factory Settings

To restore the gateway to its factory settings, proceed as follows:
1. Set all switches from DIP switches SW1 and SW2 to the ON position.
2. Reboot the gateway:
a. Power it OFF.
b. Power it ON.
NOTE
To turn the gateway OFF, disconnect it from the AC unit and from the power supply, if
there is one. To turn the gateway ON, reestablish those connections.
3. After the reboot, LEDs will blink with the SOS Morse sequence:
a. Three short blinks
b. Three longer blinks
c. Three short blinks
4. Set all switches from DIP switches SW1 and SW2 DIP to the OFF position before 30 seconds pass.
IMPORTANT
If you take longer than 30 seconds, all LEDs will turn off, meaning that the procedure has failed.
To retry it, go to step 1 and begin the procedure again.
After this procedure, the LED will flash red, meaning that the gateway is already restored to the factory settings.
To continue working with the gateway, proceed as usual:
1. Set the DIP switches again depending on the desired configuration.
2. Reset the device:
a. Power it OFF.
b. Power it ON.
Page 14 of 74
Restore the Factory Settings
USER MANUAL Version 1.0.9