Troubleshooting; Hardware - Kodak PROFESSIONAL RFS 3600 User Manual

Troubleshooting

HARDWARE

There is no power to the scanner; the status light on the top of the scanner is
not on.
Make sure all plugs are securely seated. Make sure the scanner power
button is on at the rear of the scanner. Try another power outlet.
Your computer will not start properly. You have just connected the scanner (or
you have just connected another SCSI device to the computer).
If you are using the SCSI connection, there may be a SCSI ID conflict.
All SCSI devices connected to the computer must have unique ID num-
bers. Refer to
SCSI ID on the scanner as described there (or reset the SCSI ID on the
newly connected device).
Your SCSI cables may be too long. The total length of all SCSI cables in
the chain must be less than 15 feet (4.6 meters).
A filmstrip with a splice in it will not move properly through the scanner.
Spliced film is not supported, and should not be used with the scanner.
The USB connection on a PC-Compatible is not working.
Follow the steps in
computer system is locating the scanner.
The green LED at the top right of the scanner flashes in an unending, repeated
pattern.
A problem has been detected with the scanner; turn off your computer
system and scanner, and restart.
Connecting the Scanner to Your
Making a USB Connection
86
Computer, and reset the
to ensure that your