Kodak PROFESSIONAL RFS 3600 User Manual page 91

Are you sure you want to delete the scan profile name Scan Profile?
Use this confirmation dialog box to indicate whether or not you wish to
delete the scan profile.
Auto-focus has already been performed on this slide. Select Auto to perform
auto-focus again, or select Manual to fine tune the existing focus.
For a detailed explanation of the Auto-Focus Slide button, refer to
Reference – Software (Auto-Focus
Based on your Output and Magnification values, the Scan [Height/Width] is
larger than a 35mm frame. Therefore, the Scan [Height/Width] will be set to
the maximum, the Scan [Width/Height] will be adjusted to maintain the
locked aspect ratio. This also requires the Magnification and Output Resolu-
tion to be adjusted.
For a detailed explanation of these relationships, refer to
Software (Output Size and Input
Based on your Output and Magnification values, the Scan Resolution would
need to be #### dip, which is [higher than the maximum 3600 dpi/lower than
the minimum 72 dpi]. The Scan Resolution will be set to 3600dpi/72dpi] and
the Output Resolution will be set to #### dpi.
For a detailed explanation of these relationships, refer to
Software (Output Size and Input
Do you want to cancel the [Prescan/Final Scan] currently in progress?
Make an appropriate choice, to stop scanning after the current frame
and retain all scans to this point, or to continue scanning.
If Output Width & Height are not locked: Based on your Output and Magnifi-
cation values, the Scan [Height/Width] is larger than a 35mm frame. There-
fore, the Scan [Height/Width] will be set to the maximum and the Output
[height/width] will be adjusted.
If Output Width & Height are locked: Based on your Output and Magnifica-
tion values, the Scan [Height/Width] is larger than a 35mm frame. Therefore,
the Scan [Height/Width] will be set to the maximum, the Scan [Width/
Slide).
Values).
Values).
91
Reference –
Reference –