Kodak PROFESSIONAL RFS 3600 User Manual page 19

4. If an external terminator has been removed or if none of the connected
devices is terminated internally, follow the directions in this step;
otherwise continue at the next step. In this step, you will place the
scanner at the end of the chain of connected devices; however, you can
place the scanner anywhere in the chain as long as the last device in the
chain is terminated.
A. Attach one end of your SCSI cable to the empty SCSI port on the last
device in the chain; make sure the connector is well seated.
B. Attach the other end of the cable to either of the identical SCSI ports
on the back of the scanner; make sure the connector is well seated.
C. Set the SCSI termination switch on the back of the scanner to the on
position.
D. Continue at
this chapter.
A
Setting the Scanner SCSI Identification Number
19
B
C
next in