Kodak PROFESSIONAL RFS 3600 User Manual page 94

The value you entered is too [low/high]. The value must be between 0 and
255.
Try again, but this time enter a white or black balance value from 0
to 255.
The value you entered is too low/high. The value must be between -100% and
+100%.
Try again, but this time enter a value from -100 to +100.
The White Balance value must be between 0 and 255, inclusive.
You have entered a balance value that is outside of the range. As
prompted, try again with a value from 0 to 255.
Unable to access ICC Profile [profile name]. Close and restart the scanner
software, and try again. If the problem persists, try another ICC Profile or, if
you must use this ICC Profile, reinstall the scanner software and try again.
There is a problem with the ICC profile. If the file was installed with the
scanner software, quit Photoshop, then run the installation program
again, and click Repair. Try the software again.
If the same problem occurs, quit Photoshop again. Run the installation
program, but this time click Remove. Then run the installation program
again, which will reinstall the scanner software. Try the software again.
If you obtained the file from another source, such as through a down-
load from the web, obtain and reinstall a fresh copy of that file.
Unable to communicate with the RFS 3600 Film Scanner. Try the following:
Make sure the scanner power is on
Check all cables
With a SCSI connection (not USB), check for a SCSI ID conflict or im-
proper termination of the SCSI chain. Refer to the User's Manual on the
CD as needed.
For assistance with a SCSI connection refer to
tion in this manual.
94
Making a SCSI Connec-