Kodak PROFESSIONAL RFS 3600 User Manual page 93

The film scanner is warming up. Please wait.
Wait as indicated.
The Film Type was changed after the Prescan. You may want to perform a
Prescan Frame or Prescan Strip to update the prescan images. But, this will
discard all other image adjustments you have made while previewing the
current images.
As indicated, you have changed the Film Type setting after performing a
prescan. If you have already performed image adjustments based on the
previous Film Type, they are probably incorrect and you may wish to
perform a prescan and then begin image adjustment again.
The Output Resolution must be between 72 dpi and 7200 dpi inclusive. The
value you entered is too [low/high] and will be automatically set to [72/7200]
dpi.
The output resolution you have entered is not within the range of the
scanner software. As indicated, a value from the closest end of the range
will be substituted. If that is not your intention, enter another value
within range of the scanner software.
The resolution of your monitor is too low. Increase the resolution by choosing
Start > Settings > Control Panel > Display > Settings tab. Move the Screen
Area slider to at least 800 x 600 pixels and select the OK button. Then retry
accessing the film scanner.
PC-compatible only. As indicated the monitor resolution is too low to
run the scanner software. Change the resolution as described and try
again.
The resolution of your monitor is too low. Increase the resolution by going to
the Apple Menu, selecting Control Panels and then Monitors & Sound. Click
the Resolution icon and in the Resolution listing, select a resolution setting
which is at least 800 x 600 pixels. Close the Multiple Scan Display panel and
then retry accessing the film scanner.
Macintosh only. As indicated the monitor resolution is too low to run
the scanner software. Change the resolution as described and try again.
93