Table of Contents
Advertisement
2
SAFETY
The ARM CONTROLLER has been designed and constructed in such a manner that it
can be used safely. This applies to the use, the circumstances and the regulations as
described in this documentation. Reading this documentation and following the
instructions are therefore necessary for everyone who is authorised to work with the
ARM CONTROLLER.
The ARM CONTROLLER must be used in surroundings that:
•
Have a stable temperature of between -10 and 50 °C.
•
Are free of dust, corrosive gases and high concentrations of organic vapours.
•
Are not situated in the vicinity of a source of vibration.
2.1
GENERAL SAFETY RULES
•
Only authorised personnel may carry out work with the ARM CONTROLLER.
•
Do not arm the ARM SYSTEM if there are people or animals in the direct output
or in the safety zones of the SFX machines connected to the ARM
CONTROLLER. For details, refer to the corresponding user and installation
manuals of the machines.
•
Make sure that children, unauthorised persons and animals do not obtain
access to the ARM CONTROLLER.
•
Make sure there are no free-standing objects or objects that can be
damaged by the connected machines within the output distance.
•
Do not remove any safeguards, safety caps and safety symbols.
•
All required safety devices must be in good condition and function properly.
•
Ensure sufficient lighting of the surroundings.
•
Keep the workplace clean.
•
Make sure that the ARM SYSTEM is always tested and validated at the site
before an event takes place.
2.2
INSTALLATION
WARNING
WARNING
10
MAGICFX
SFX SAFETY ARM CONTROLLER — User and Installation Manual
®
As a supervisor, make sure that each ARM component, control
device and SFX machine in the ARM SYSTEM is correctly installed
in accordance with the ARM SYSTEM configuration associated
with the SFX setup and the risk reduction strategy for the event.
For configuration instructions, refer to the ARM SYSTEM
Configuration Manual.
Make sure that each ARM component, control device and SFX
machine in the ARM SYSTEM is correctly installed in compliance
with the instructions from the corresponding user and installation
manuals from MAGIC FX.
Advertisement
Table of Contents
Need help?
Do you have a question about the SFX SAFETY ARM CONTROLLER MFX3220 and is the answer not in the manual?