Confirm The Ip Address, Test The Audio, And Check The Volume - CyberData VoIP Ceiling Speaker Operation Manual

8 Installing the VoIP Ceiling Speaker
Speaker Setup

2.2.3 Confirm the IP Address, Test the Audio, and Check the Volume

When the speaker is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
IP Address, test that the audio is working, and check the volume.
To announce a speaker's current IP address:
1. Press and hold the RTFM switch until it beeps (after one second).
2. Release the switch to hear the IP address announcement, and check the speaker volume.
Note
CAUTION Pressing and holding the RTFM switch for longer than 20 seconds will restore the
CyberData Corporation
The speaker will announce it's default IP address (192.168.3.10).
speaker to the factory default settings. See
(Figure 2-4) on the speaker face to announce and confirm the speaker's
Figure 2-4. RTFM Switch
Section 2.6, "Restore the Factory Default
930095H
RTFM switch
Settings".
Operations Guide