Using The Support Software Port - Omron E5AN User Manual

Using the Support Software Port

2-3 Using the Support Software Port
Procedure
1,2,3...
• Connect terminals 14 and 15 when using the E53-CN@@PBN2 as the
external power supply for the ES1B.
• Connect terminals 14 and 15 when using the E5AN/EN-@@P@-N as the
external power supply for the ES1B.
E53-CN@@PH@N2 E53-CN@@PBN2
11 (+)
( )
12
• The following table provides the specifications of the external power sup-
ply for ES1B.
Output voltage
Output current
Note Contact your OMRON representative for information on using the
external power supply for ES1B for other applications.
Use the communications port for Support Software to connect the personal
computer to the Temperature Controller when using EST2-2C-MV4 CX-
Thermo or a version of CX-Thermo higher than 4.00, or other Support Soft-
ware. The E5GN is supported from CX-Thermo version 4.2. The E58-CIFQ1
USB-Serial Conversion Cable is required to make the connection.
For information concerning the models that can be used with CX-Thermo,
contact your OMRON sales representative.
Use the following procedure to connect the Temperature Controller to the per-
sonal computer using the USB-Serial Conversion Cable. The USB-Serial
Conversion Cable is used to communicate with the COM port of the personal
computer. To perform communications using USB-Serial Conversion Cable,
set the communications port (COM port) number to be used for the software
to the COM port assigned to the Cable.
1. Turn ON the power to the Temperature Controller.
Note If the Cable is connected when the power to the Temperature Con-
troller is OFF, power will be supplied from the personal computer
and impose a load on the internal circuits of the Temperature Con-
troller.
2. Connect the Cable.
Connect the personal computer's USB port with the Support Software port
on the Temperature Controller using the Cable.
E5AN/EN-@@P@-N
14 (+) 14
( )
15 15
12 VDC 10%
20 mA max.
Section 2-3
(+)
( )
45