Omron E5AN User Manual page 71

Wiring Terminals
Note
2-2-3 Wiring
Power supply
6 mm
Ferrules
• Recommended Ferrules for SUB2 on E5GN
Manufacturer
Phoenix Contact
Do not remove the terminal block from the E5AN, E5EN, or E5CN. Doing so
may cause product malfunction or incorrect operation.
In the connection diagrams, the left side of the terminal numbers represents
the inside of the Controller and the right side represents the outside.
• With the E5CN, connect to terminals 9 and 10; with the E5CN-U, connect
to pins 10 and 11; with the E5AN, E5EN, and E5GN, connect pins 1 and
2. The following table shows the specifications.
Input power supply
100 to 240 VAC, 50/60 Hz 7.5 VA
24 VAC, 50/60 Hz
24 VDC (no polarity)
• These models have reinforced insulation between the input power supply,
the relay outputs, and other terminals.
6 mm
Wires
Model number
AI 0,25-6 BU
AI 0,34-6 TQ
AI 0,5-6 WH
AI 0,75-6 GY
AI 1-6 RD
E5CN E5CN-U
6 VA
5 VA 3 VA
3 W 2 W
Section 2-2
E5AN/EN E5GN
10 VA 5.5 VA
5.5 VA 3 VA
4 W 2 W
35