Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual page 227

Operation If Errors Are Displayed
OK Button clicked
Ignore Errors Button clicked
• Using CX-Integrator Ver. 2.0 or Higher for a Controller Link Network: Confirming
Data Link Modes (Automatic/Manual) When Transferring Data Link Tables
The following dialog box for confirming data link modes will be displayed when the
OK Button is clicked after completing data link table transfer.
1 Click the Yes Button to confirm the data link mode settings.
The data link mode setting will be read from all nodes on the network.
Note: If a local network table has not been registered (i.e., if the network address is 0), a Unit
Selection Dialog Box will be displayed. If that occurs, select the Controller Link Unit on
the required network.
2 The following dialog box will be displayed showing the data link mode settings.
• The following dialog box shows that all nodes are set to the same mode.
• The following dialog box shows that the data link mode settings could not be read.
4-3 Manually Setting Data Links
4-3-11 Transferring the Data Link Table
The data link tables will not be transferred.
An error message will be displayed if a node does not
actually exist on the network. If the Ignore Errors
Button is clicked, data link tables will be transferred to
the nodes that do exist.
4-35