Sennheiser SDC 8000 SYS Software Manual page 84

Configuring the interpretation system
84
Click the "Yes" button.
All active interpreter consoles are deactivated and the "Sending" info
box appears. The configuration data are transmitted to the central unit.
To initialize the interpreter consoles:
Click the "Reset" button.
The "Are you sure ?" dialog box opens.
Click the "Yes" button.
Your interpretation system is now ready for operation, if, compared
with the previously transmitted and initialized configuration:
only the languages assigned to the booths, the modes between or
within booths or the options have been changed,
the number of booths has not been changed,
the number of consoles per booth has not been changed.
The following operating steps are only nexcessary if:
the number of booths and/or
the number of consoles per booth has been changed.
In the palette, click the "Deskinit" button.
The "Initialize Units" dialog box opens.
To initialize all interpreter consoles (e.g. when initializing the
interpretation system for the first time or after rearranging the system):
Click the "Full Init" button.
The signal light rings on all interpreter consoles start flashing and the
displays of the consoles show the booth number (Booth) and the desk