Parameter List; Parameter Groups; Setup - THOMSON MEC 310#GENSET CONTROLLER Installation And Operation Manual

MEC 310 GENSET CONTROLLER

5. Parameter list

This chapter includes a complete standard parameter list for setup. Therefore, this chapter is to be
used for reference, when information about specific parameters is needed.

Parameter groups

In the parameter overview, the parameters are divided into three parameter groups. The parameter
groups can be enabled and disabled in the parameters 6950-6970. If a parameter group is enabled,
the parameters will be accessible from the display of the MEC 310. To see the specific parameter,
see in the parameter list. If e.g. a parameter is marked (P2), it is available from the display, if
parameter group 2 is enabled. The default display parameter setting is the parameter setting that
will always be present in the display parameter list. These parameters are marked with a *.

Setup

The setup of parameters is performed via the display or the TPS 300 software. Therefore, the
default settings can be changed to the relevant settings through the TPS 300 software or by means
of the push-buttons on the display.
The settings can be entered through the setup menu. If no entry has taken place before, then the
first display to appear is the password display. Enter the factory setting password to gain access to
the menus.
The factory Customer password is 2000. The factory Service password is 2001.
If no action has been taken after 30 seconds, then the password entry will be deactivated, and a
new password entry is needed. (If entry via the TPS 300 is used, the password is only needed once
per connection).
PM075 REV 2 09/08/20 Page 86 THOMSON TECHNOLOGY