Rpm Input - THOMSON MEC 310#GENSET CONTROLLER Installation And Operation Manual

4510 Overspeed 1 (RPM input)
No. Setting
4511 Overspeed 1
4512 Overspeed 1
4513 Overspeed 1
4514 Overspeed 1
4515 Overspeed 1
4516 Overspeed 1
4520 Overspeed 2 (RPM input)
No. Setting
4521 Overspeed 2
4522 Overspeed 2
4523 Overspeed 2
4524 Overspeed 2
4525 Overspeed 2
4526 Overspeed 2
Overspeed 1 and 2 are always active if enabled regardless of nominal setting.
Thus it is possible to set two levels of overspeed.
4560 Hz/V failure
No. Setting
4561 Hz/V failure *
4562 Hz/V failure
4563 Hz/V failure
4565 Hz/V failure
4566 Hz/V failure
When the frequency and voltage have not been OK for the adjusted delay time, a Hz/V failure
alarm occurs, and output A and B activate.
4580 Stop failure
No. Setting
4581 Stop failure *
4582 Stop failure
4583 Stop failure
If the engine has not stopped within the delay time, outputs A and B will activate and a stop failure
alarm occurs.
PM075 REV 2 09/08/20
MEC 310 GENSET CONTROLLER

RPM input

Min. setting
Set point 0%
Timer 0.2 s
Relay output A R0 (none)
Relay output B R0 (none)
Enable OFF
Fail class
Min. setting
Set point 0%
Timer 0.2 s
Relay output A R0 (none)
Relay output B R0 (none)
Enable OFF
Fail class
Min. setting
Timer 1.0 s
Relay output A R0 (none)
Relay output B R0 (none)
Enable OFF
Fail class
Timer
Relay output A
Relay output B
Page 100
Max. setting
400%
100.0 s
R26 (relay 26)
R26 (relay 26)
ON
See description of fail classes
Max. setting
400%
100.0 s
R26 (relay 26)
R26 (relay 26)
ON
See description of fail classes
Max. setting
99.0 s
R26 (relay 26)
R26 (relay 26)
ON
See description of fail classes
Min. setting Max. setting
10.0 s 120.0 s
R0 (none) R26 (relay 26)
R0 (none) R26 (relay 26)
Factory
setting
160%
15.0 s
R0 (none)
R0 (none)
OFF
Factory
setting
160%
15.0 s
R0 (none)
R0 (none)
OFF
Factory
setting
30.0 s
R0 (none)
R0 (none)
ON
Factory
setting
30.0 s
R0 (none)
R0 (none)
THOMSON TECHNOLOGY