Push-Buttons, Leds And Display; Unit - THOMSON MEC 310#GENSET CONTROLLER Installation And Operation Manual

This chapter deals with the display including the push-button and LED functions.
Front dimensions H x W
Unit depth
Push-button functions
The push-buttons on the unit have the following functions:
RUN :
Start engine (local (not auto)) running mode.
Breaker
CLOSE.
OFF :
Stops the engine immediately.
If the unit is in AUTO mode,
the mode will change to MAN
and the engine will stop.
PM075 REV 2 09/08/20
MEC 310 GENSET CONTROLLER

5. Push-buttons, LEDs and display

Unit

AUTO running mode
selector.
Breaker TRIP.
MAN :
Manual running mode
selector.
Page 24
160 x 220 mm (6.30" x 8.66")
54 mm (2.13 ")
Reset horn relay.
▲:
Normal display: Scrolls
the display up once.
Programming:
Increases set point
value.
:
Enters value or ack-
nowledges alarm.
▼:
Normal display: Scrolls
the display down once.
Programming:
Decreases set point
value.
ESC :
Jumps from parameter
settings to display.
TEST :
Activates the selected
test in the entered
time.
Lamp test :
Activates all LEDs for
3 seconds.
THOMSON TECHNOLOGY