Volvo Penta Ems 2 (J1939) - THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 Manual

MEC 310 GENSET CONTROLLER - Option J – CANbus J1939
EMS 2 and EDCIII/D6, D7, D9, D12 and D16 (GE and AUX variants only).
Warnings and shutdowns
Warning/shutdown list
Low oil pressure
Intake manifold #1 P
Coolant temperature
High inlet air temp.
Fuel temperature
Fuel pressure
Oil level
Overspeed
Coolant level low
EIC yellow lamp
EIC red lamp
FMI indication " – " means that the alarm in question is not supported,
Write commands to engine controller
Engine controls
•
All the write commands to the engine controller (ex: speed, start/stop, etc.) are enabled in
setting 7563 (EIC Controls).
Engine speed
•
CANbus ID for speed control: 0x0cff4611 – Volvo Penta proprietary telegram.
• Preheat
• Start/stop
Readable states
• Preheat and running
The speed regulation is enabled in setting 2781 (Reg. output) and 7563 (EIC
Controls).
Selection of primary or secondary speed is selected in setting 2774.
PM077 R1 09/08/20

Volvo Penta EMS 2 (J1939)

SPN
100
102
110
172
174
94
98
190
111
-
-
Page 30
J1939 codes
FMI FMI
warning shutdown
5 -
- -
5 -
5 -
- -
5 -
5 -
- 0
- 1
X -
- X
THOMSON TECHNOLOGY