Volvo Penta Ems (J1939) - THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 Manual

MEC 310 GENSET CONTROLLER - Option J – CANbus J1939
Frequency selection
•
Nominal speed/frequency is selected in 2772. If 'User' is selected, nominal
speed/frequency is written automatically, based on the frequency nominal setting.
• Start/stop command
The speed regulation is enabled in setting 2781 (Reg. output) and 7563 (EIC
Controls).
It is only possible to write commands to the engine when the Scania Coordinator
is NOT mounted.
Control
In the parameter 2770 it is possible to configure the droop setting and the initial speed setting.
Warnings and shutdowns
Warning/shutdown list
Low oil pressure
Intake manifold #1 P
Coolant temperature
High inlet air temp.
Fuel temperature
Fuel pressure
Oil level
Overspeed
Coolant level low
EIC yellow lamp
EIC red lamp
Write commands to engine controller
None.
PM077 R1 09/08/20

Volvo Penta EMS (J1939)

J1939 codes
SPN warning
100
102
110
172
174
94
98
190
111
-
-
Page 29
FMI FMI
shutdown
5 -
- -
5 -
5 -
- -
5 -
5 -
- 0
- 1
X -
- X
THOMSON TECHNOLOGY