J1939 Measurement Table - THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 Manual

MEC 310 GENSET CONTROLLER - Option J – CANbus J1939
This is the common J1939 measurement overview showing which measurements are available.
Note that not all measurements are supported by the individual engines; please refer to the specific
engine description.
The table shows which values can be displayed in the view screens.
For information about the menu structure, please see the Installation and
Operation Manual.
The display values corresponding to the engine communication have a description beginning with
'EIC'.
Error messages
The following error messages can occur:
Message
Engine I. value N.A.
Value selected error
'N.A.'
PM077 R1 09/08/20

J1939 measurement table

Description
The view is not selectable for the present engine type.
The value cannot be read due to sensor error, sub-system or
module error.
The value is not supported by the engine, or due to
communication error.
Page 6 THOMSON TECHNOLOGY