Functional Description; Engine Types - THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 Manual

MEC 310 GENSET CONTROLLER - Option J – CANbus J1939
This communication extracts information from the Electronic Control Module (ECM) of an engine
equipped with an ECM module with CANbus interface. The values can be used as display values,
alarms/shutdown alarms and values to be transmitted through Modbus.
Data can be transmitted between the MEC 310 units and the following engine controllers/types:
Engine Manufacturer
Caterpillar
Cummins
Detroit Diesel
Deutz
-
Iveco
John Deere
MTU
MTU
MTU
Perkins
Scania
Scania
Volvo Penta
Volvo Penta
Volvo Penta
Rx/Tx: Please go to the section 'Specific engine type descriptions' for details of
data read and write.
The engine type is selected in menu 7561.
For support of controller/engine types not listed, please contact Thomson
Technology.
PM077 R1 09/08/20

3. Functional description

Engine types

Engine Controller/Type
ADEM III and A4/C4.4, C6.6, C9, C15,
C18, C32
CM570, CM850/QSL, QSB5 & 7,
QSM11, QSK19, 50 & 60
DDEC III and IV/Series 50, 60 & 2000
EMR 2 (EMR)/912, 913, 914 and L2011
General J1939
EDC7 (Bosch MS6.2)/Series NEF,
CURSOR and VECTOR 8
JDEC/PowerTech M, E and Plus
MDEC, module M.302 or M.303/Series
2000 and 4000
MDEC, module M.201 or M.304/Series
2000 and 4000
ADEC/Series 2000 and 4000
Series 1100, 1300, 2300 and 2800
EMS
EMS S6 (KWP2000)/Dx9x, Dx12x,
Dx16x
EDC4
EMS
EMS 2 and EDCIII/D6, D7, D9, D12 and
D16 (GE and AUX variants only)
Page 4
Comment
Rx/Tx
Rx/Tx
Rx/Tx
Rx/Tx
Rx/Tx
Rx/Tx
Rx/Tx
Rx
Rx
Select M.303
Rx/Tx
Rx/Tx
Rx
Rx/Tx
Rx
Select EMR 2
Rx
Rx/Tx
THOMSON TECHNOLOGY