Table of Contents
Advertisement
Removal of the combined switch / fuse holder unit
Remove here
Service
9.
Service
9.1 Maintenance
!
Disconnect unit from mains supply.
Unplug plug.
The HAAKE MiniJet Pro requires no special periodical main-
tenance work. However, the unit must be kept clean at all
times.
The moving parts should be cleaned regularly.
If you have doubts about correct operation of the HAAKE Mini-
Jet Pro, a test run should be carried out. See chapter 8.9. be
9.1.1 Replacement fuses (see chapter 6.5.1)
Fuses are not in the
scope of delivery.
9.2 Taking care of the unit
9.2.1 Taking care and cleaning of the molds
!
To clean the mold surface without scratching the
surface, use only a copper brush.
!
Do not use any sharp objects (e.g. a scalpel or
screw driver) to release the moulded part from the
mold.
Before being put into storage for an extended period, spray
the mold with a suitable medium (e.g. teflon spray) in order
to protect the surface against rust. This medium must be re-
moved from before using the mold. Acetone, for example,
can be used to do this.
24
An additional fuse mark on the
switch indicates the fuses holders
behind the switch. The red frame
shows the outline of the removable
unit.
With a simple tool like a Swiss Army
knife or a screwdriver No 1 or smaller
the unit (1) can be removed from the
filter. On the topside (2) behind the
switch there are two fuse holders for
each live connection. On the bottom
side (3) is a clip to carry an additional
spare fuse.
Advertisement
Table of Contents
